Smoke Alarm Support Resources
SMOKE ALARM PAIRING TROUBLESHOOTING
Return to the Troubleshooting Process or view our other Smoke Alarms.
If further issues present or assistance is required, please contact our friendly team for advice via our form, by email or call 1800 281 282.
(Use the FSA-26000 troubleshooting guide for Superseded model codes FSA-15000, 18000, 20000, & 25000)
PAIRING MATelec AUSTRALIA SMOKE ALARMS
Notes:
- A combination of wired and wireless units can be used in a single install.
- If pairing FSA-60000s and FSA-30000s with no remote, ensure the FSA-60000 is the master as it is hard wired.
- If using an FSA-90000, ensure you treat this as the master
WITH AN FSA-90000 (REMOTE)
The remote should always be used as the master.
- Ensure all alarms to be paired are within 2m of the remote.
- Press the NET button on the remote so a red-light illuminates. (Will remain in this setting for 30 seconds).
- Pair the first smoke alarm by pressing the centre/test button 3 times.
- The red light on the remote will flicker briefly when each unit is connected.
- FSA-30000 pairing units will illuminate green.
- FSA-60000 will emit a single chirp.
- Repeat the above steps for remaining units (One at a time, within 30 seconds between pairings).
Pairing Two Remotes Together
- Press the NET button on the first remote
- You will see a red light come on under the test button
- Press the NET button on your second remote
- The red light will flash on both remotes
- The two remotes have been successfully paired
FSA-25000, 26000s to Each Other
The FSA-25000 and FSA-26000 are hardwired models and do not require pairing.
FSA-60000s to Each Other
The FSA-6000 can be either hardwired or wirelessly interconnected using the FSA-50000.
Pairing a Remote to FSA-60000s & FSA-30000s
- Press the NET button on the first remote
- You will see a red light come on under the test button
- FSA-60000 - Press ‘Test’ button on smoke alarm 3 times (should beep once)
- FSA-30000 - Press the centre button 3 times (red light will come on then turn green)
FSA-30000s or FSA-60000s With Modules to Each Other
- If possible, it is ideal to have all units assembled ready for pairing in one place
- Nominate a Master unit (The unit all other units will pair to. The master must be an FSA-60000, if present)
- Ensure all alarms are turned on or have battery inserted.
- On the Master unit press the test/centre button 3 times within 2 seconds to initiate pairing mode.
- FSA-60000 will have a solid red light on the front.
- FSA-30000 will have a blue light on the back.
- On the next unit, press the test/centre button 3 times within 2 seconds to pair to the master.
- FSA-60000 will chirp.
- FSA-30000 will show a green light on the back.
- Repeat this process for the rest of your alarms, one by one.
